Element Bidore, Руководство пользователя и инструкция по установке

Страница: 9 / 40

9
USER INFORMATION
Setting times for the timer
To set the timer, proceed as follows:
Set the day and night temperature as described
above
Briefly press the SET button to enter the (P*)
TIMER position.
Press the SET button until P1 TIMER is
displayed and the time flashes.
Set the first switch on time of the day temperature
using the buttons
(large flame) and (small
flame).
Briefly press the SET button to set the next time
of the cycle, P1 TIMER.
Successively set the times P2 TIMER and
P2 TIMER.
Press the OFF button or wait until position (P*)
TIMER appears on the display.
Activating the timer function
Follow the steps below for activating the timer
control:
Place the appliance in the standby (pilot burner)
position using button (small flame).
Set the day/night temperature if you have not
yet done so;
Set the timer times P1 TIMER, P1 TIMER,
P2 TIMER and P2 TIMER.
Choose the (P*) TIMER function using the SET
button.
Replacing the battery
If the battery is almost empty, the display will
show “BATT”.
To replace the battery, proceed as follows:
Remove the cover at the back side of the
remote control.
Disconnect the 9V block battery from /
connect the 9V block battery to the connector.
!Caution - Observe the “+” and “-” poles of
the batteries and the connector;
- Use alkaline batteries;
- Batteries are regarded as “small chemical
waste” and may therefore not be disposed
with the household rubbish.
Place the battery in the holder.
Replace the cover.