Element Bidore, Руководство пользователя и инструкция по установке

Страница: 3 / 40

3
ing regulations. It is therefore recommend that
a registered gas installer be employed for this
task. The engineer will provide you with informa-
tion about the safety limits of the installation and
should fix a notice plate in a place where it can
be readily seen.
This appliance is designed as an efficient heating
device and consequently all body parts become
very hot in use. Except for the control knob and
control access door, which are designed to stay
cool, all other parts are working surfaces and
should not be touched.
The glass and frame on this appliance acts as
a fireguard conforming to BS: 1945 – 1971 and
satisfies the Heating Appliance (Fireguards)
regulations 1991. No part of the window or frame
should be permanently removed. It does not
give protection for young children aged or
infirm
, extra guarding(conforming to BS8423:
2002) should be considered so the special
hazards that exist in nurseries and other places
where there are young children, aged or infirm
persons are minimized.
Bearing in mind that the heat given off by this
appliance may affect articles placed close to it,
curtains should not be placed within 30cm.
The appliance is not designed as a dryer. It is not
therefore recommended that the appliance be
used in such a manner. Do not place any articles
within 30cm of this appliance as this may result
in damage to the articles.
The installation must be carried out in accord-
ance with the following regulations:
The Building Regulations issued by the Depart-
GENERAL INFORMATION
Important Safety Notice
This appliance has a ceramic Fire-bed arrange-
ment; this contains Refractory Ceramic Fibres,
which are man-made vitreous silicate fibres.
Excessive exposure to these materials can
cause irritation to eyes, skin and respiratory
organs. Hence we recommend that when han-
dling these materials the release of dust should
be kept to a minimum. During installation and
servicing we recommend that a HEPA filtered
vacuum be used to remove any dust and soot
in and around the fire. If any of the ceramic
fire-bed components need to be replaced we
recommend that the removed parts be sealed in
a heavy-duty polythene bag, and be labelled as
RCF waste. RCF is not “Hazardous waste” and
can be disposed of at a licensed tipping site for
the disposal of industrial waste.
The appliance incorporates a permanent pilot.
This is located on the front of the burner, and
must not be adjusted by the installer. This system
must not be put out of operation, and if any parts
require changing, only original manufacturer
parts shall be used.
This appliance is designed to be used either
Natural or LPG gas however, each individual
appliance is only capable of running off the type
of gas specified at the time of purchase. It is im
-
portant to note that once a type of gas has been
specified the stove cannot run off any other type.
The type of gas that your stove is capable of
burning is stated on the data information panel.
This appliance has been designed, tested and
approved to meet standards in place for prod-
uct use, performance and safety. Installation of
your appliance must comply with current build-