Element Bidore, Руководство пользователя и инструкция по установке

Страница: 32 / 40

32
"Problem”
A. No transmission
(motor will not run)
B. No ignition (spark)
C. No sound signal
D. One continuous sound sig-
nal of 5 sec.
(Possible 7 short beeps prior to
the 5 sec. sound signal)
E. No pilot burner flame
1. The (new) communication code between
receiver and remote control must still be
confirmed.
2. Empty batteries.
3. Receiver is damaged.
4. Remote control is damaged.
5. Motor cable at valve/receiver is broken.
6. Bent pins of the 8-wire connector.
7. If the receiver is surrounded by metal,
this could decrease the transmission range.
1. Button A in position MAN.
2. Ignition cable runs over and/
or alongside metal parts.
3. Ignition pen corroded.
4. 60-second delay before the full restart is
not yet finished.
1. Receiver is damaged.
2. 60-second delay before the full restart is
not yet finished.
1. Loose wiring between receiver and gas
control.
2. Receiver is damaged.
3. Bent pins of the 8-wire con- nector.
4. Damaged magnetic valve.
1. Air in the pilot burner pipe.
2. Wires of thermocouple have been cross-
connected.
3. No spark at the pilot burner.
4. Injector is blocked up.
1. Hold down the reset button of the re-
ceiver, until you hear a long beep . Let go
of the reset button after the second, longer
sound signal and press button (small
flame) or button (large flame) on the re
-
mote control within 20 sec., until you hear
an extra long sound signal confirming that
the new code has been set.
2. Replace batteries.
!Caution Avoid short circuit between the
batteries and metal parts of the appliance.
3. Replace the receiver and confirm the
code (remedy 1).
4. Replace the remote control and
confirm the code (remedy 1).
5. Replace the motor cable.
6. Make sure that the pins of the 8-wire
connector are straight.
7. Change the position of the antenna.
1. Switch button A on the gas control to
ON (figure 1)
2 Do not place the ignition cable over
and/or along metal parts. This will weaken
the spark;
If necessary, replace the ignition cable.
3. Replace the ignition pen.
4. Wait until the delay time has passed.
1. Replace the receiver and confirm the
code (remedy 1 at A)
2. Wait until the delay time has passed.
1. Connect the wiring properly.
2. Replace the receiver and confirm the
code (remedy 1 at A)
3. Make sure that the pins of the 8-wire
connector are straight.
4. Replace the gas control.
1. Flush the pipe or start the ignition pro-
cess several times.
2. Check the polarity of the thermocouple
wiring.
Connect the thermocouple wiring pro-
perly, if necessary.
3.1 Check if the ignition cable is lying free
from metal parts;
If necessary, move it away from the metal
parts.
3.2 If necessary, replace the ignition cable.
3.3 If necessary, replace the ignition pen.
4.1 Clean the injector.
4.2 If necessary, replace the injector.
"Possible cause” "Remedy”
TROUBLE SHOOTING