elektronik star 10004911, Руководство пользователя

Страница: 9 / 10

Laundry Guide
Cleaning After Use

Cleaning after use will extend your washing machine. Before cleaning turn off the power switch and
disconnect the power cord from the electrical outlet.
Over Flow Lint Filter
 Remove the lint filter by pulling it forward.
 Wash away the lint stuck in the filter during overflowing.
 Re-install the lint filter: By first inserting its bottom section and then pushing the upper part firmly
into place.
Points to Remember
 Avoid using excessive amounts of bleach, soap powder or detergent. Use the amount recommended
by the respective manufacturers.
 For your safety, ensure that the ground connection is correct.

Never put your hands into the spin tub while it is operating.
 When washing, the water temperature should be below 50°C. This is to prevent the plastic
components from becoming deformed.
 Do not placed the washing machine close to heat-generating products such as gas cookers or
electric kettle.
 When cleaning the washing machine, try to use soft cloth. This will prevent damages to the surface
of the cabinet.
 'Avoid placing a wet load on the control panel.
 Do not place the washing machine out door or damp area such as the bathroom.
Before You Call For Service
There may be times when you suspect your washing machine requires maintenance. Before calling for a
service engineer, please check the following points, to save unnecessary cost. You may be pleasantly
surprised that an apparent malfunction can be easily rectified by following the chart below:
If your washing machine will not start, check whether:
 The hose circuit breaker is tripped or a fuse is blown.
 The cord is firmly connected to the power point or the power point is not switched on.
 Something is preventing the pulsator from rotating.
 The wash timer is set.
If the spin dryer will not operate, check whether:
 The inner lid and outer spin bowl-lids are closed.
 The spin dry timer is set.
If there is excessive noise, check whether:
 Something is touching the pulsator as it rotates.
 The machine is not placed on a level surface.
 The wash load in the spin bowl is excessively unbalanced during the spin cycle.

An article is lodged between the spin bowl and tub.