Elektor 1SD 510, Инструкция по эксплуатации и сборке

Страница: 16 / 28

16
Operating and assembly instructions SD www.elektror.com
0241
18 07.16/06
EN
8 DECLARATION OF INSTALLATION CONFORMITY PURSUANT TO ANNEX II 1 B
The manufacturer,
Elektror airsystems gmbh
Hellmuth-Hirth-Strasse 2
D-73760 Ost
fi ldern
hereby declares that the product to which this declaration refers meets the basic requirements of the Machinery Directive (2006/42/
EC) as set forth below.
Description of incomplete machine:
Side channel blower SD 20 M, SE 20, SD 22 M, SE 22, SD 24 M, SE 24, SD 2n M, SE 2n, SD 4n, SE 4n, SD 42, SE 42,
1SD 510, SD 6, 1SD 710, SD 7, SD 72, SD 80, SD 8, SD 82, SD 90, SD 9, SD 92, 1SD 910, SD 400, SD 420, SD 540, SD 600,
SD 740, SD 800, SD 820, 2SD 740, 2SD 840, 2SD 940
SD 22 FU/FUK, SD 4n FU/FUK, 1SD 510 FU/FUK, SD 7 FU/FUK,
SD 2n-1, SD 4n-1, SD 6-1, SD 7-1, SD 8-1, SD 9-1
Serial number and year of manufacture can be found on the nameplate and on the accompanying delivery slip.
Description of the essential requirements of Machinery Directive (2006/42/EC), with which the partially completed machine
complies:
Machinery Directive (2006/42/EC): Annex I, Articles 1.1.2, 1.1.3, 1.1.5, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.5.1, 1.6.1, 1.7.1, 1.7.3
Electromagnetic Compatibility Directive (20147/30/EC)
The partially completed machine described here continues to ful fi l the protective regulations of the Low Voltage Directive
(2014/35/EC) according to Annex I, No. 1.5.1 of the Machinery Directive.
The commissioning of the partially completed machine is not permitted until it has been veri fi ed that the machine in which the
partially completed machine is to be installed, complies with the provisions of the Machinery Directive (2006/42/EC).
The following harmonised standards were applied:
DIN EN 12100 2011 Safety of machinery - General principles of design -
Risk assessment and risk reduction
DIN EN 60034-1 2011 Rotating electrical machines,
Part 1: Rating and performance
DIN EN 60034-5 2007 Rotating electrical machines,
Part 5: Degrees of protection provided by the integral
design of rotating electrical machines (IP code) – Classi
fi cation
DIN EN 60204-1 2007 Safety of machinery – Electrical equipment of machines,
Part 1: General requirements
DIN EN 60664-1 2008 Insulation coordination for equipment within low-voltage systems,
Part 1: Principles, requirements and tests
The manufacturer, Elektror airsystems gmbh, undertakes to make the special documentation on this incomplete machine available,
electronically or in hardcopy, to national authorities on demand.
The special technical documentation belonging to this incomplete machine was prepared in accordance with Annex VII Part B.
Mr Steffen Gagg, tel. +49(0)711/31973-124, is responsible for the documentation.
Kreher (Managing Director)
Ost
fi ldern, 02.05.2016