ElectroSmash Germanium Fuzz, Руководство пользователя, Страница: 5 / 11

STEP 5 – Place the Audio Components:
These are the most important components for the sound. You have to place R1, R2,
C1, C2, C3, Trimmer1, Trimmer2, RV1 (1K pot), RV2 (500K pot), and the spring.
Note: Before placing the Trimmers, you have to pre-set them to a good value. Using
a multimeter in resistor mode (Ω) measure between pins 1 and 2, adjusting them to:
*Note:
Take care that the spring does not touch any pads; it has to be raised 3mm.
Note: Do not solder the LED, just place it in the holes, but don’t solder it yet.
 Trimmer1: 33KΩ
 Trimmer2: 8.2KΩ
Note: It is a good idea to mark where the turret board
components need to be bent using a marker pen.
*