Electronics International MVP-50P, Руководство по установке

Страница: 67 / 105

67
Symptom: Symptom:
Symptom: Symptom:
Symptom: Inaccurate, jumpy or zero reading.
1. Problem: An Isolator was NOT used between the EDC RPM channel and the P-lead at the back of
the Mag Switch. The signal on the P-lead is hundreds of volts and this could damage the
RPM input to the EDC.
a) Action: Check that there is an Isolator(s) in line with the RPM signal wires from the EDC.
If only one RPM channel is working, swap the wires to the EDC RPM channel and
see if the problem follows the EDC channel or the wire to the P-lead.
2. Problem: The Isolators in line with the EDC are incorrect.
a) Action: If the RPM reading is jumping high, add a “47” or “79” Isolator in series with the
existing Isolator. The signal from the P-lead is too strong.
If the RPM signal is from an electronic ignition, there should NOT be any Isolators
in the wire to the EDC. The EDC RPM input triggers at 3 volts.
7.6 Fuel Flow Problem:
Fuel Flow is measured using a Flow Transducer. Power (+10 volts on the Red wire) and ground (Black wire) is
supplied to the transducer from the EDC. A rotor in the transducer spins and produces pulses (0 to +5 volts) on
the White wire. The +5 volts portion of the pulse on the White wire comes from a pull-up resistor in the EDC.
The K-factor found in the “Add Fuel” screen calibrates the pulses to a flow rate.
Symptom: Symptom:
Symptom: Symptom: Symptom: Inaccurate readings.
1. Problem: The K-factor is incorrect.
a) Action: Check that the K-factor (found in the “Add Fuel” screen) is correct for the trans-
ducer installed in the aircraft (FT-60 red cube = 68,000, FT-90 gold cube = 33,800
and the FT-180 black cube = 22,400).
Symptom: Symptom: Symptom: Symptom: Symptom: Inaccurate, jumpy or zero reading.
1. Problem: A wire is open, shorted or mis-wired.
a) Action: Measure the voltage on the transducer wires from the EDC at the Flow Transducer.
The Red lead = +10 volts, Black wire = 0 volts, White wire = + 5 volts with the
White wire removed from the flow transducer.
Ohm the Black wire to ground. The Black wire must be shorted to ground (< 10
ohms).
Rapidly tap the White transducer wire to ground. A small fuel flow reading should
show on the MVP.