Electronics International AV-17, Инструкции по эксплуатации и монтажу

Страница: 10 / 15

8
D. Connect the 9-Pin Wire Harness and Route Wires:
Connect the 9-pin Wire Harness to the AV-17 and route the wires as shown below. Tie wrap all the wires so
they do not obstruct the freedom of travel of any controls . See the AV-17 Wiring Diagram at the back of this
manual.
The Orange Wire (AV-17 Voice Warning Output) may be connected using several different methods. The
methods listed below are in order of preference:
1. Connect the AV-17’s Orange Wire to the pilot’s headphone female connector (tip).
Note: If the co-pilot’s headphones are paralleled with the pilot’s headphones (which is usually the case),
both the pilot and co-pilot will hear the AV-17 voice warnings. If the passengers' headphones are paral-
leled with the pilot's headphones, the passengers also will hear the AV-17 voice warnings.
Note: The AV-17’s output impedance is designed to have little or no effect on the intercom or audio panel
output volume.
AV-17 9-Pin Connector
AV-17
Wire Color: Connects to:
Black Ground - Use the same ground
as the audio panel or
intercom.
Red 12-Volt Radio Bus via one
amp fuse (open for a 24-Volt
system).
Yellow 24-Volt Radio Bus via one
amp fuse (open for a 12-Volt
system).
White/Brown
White/Red
White/Orange
AV-17 Control Panel Wires
(match colors).
White/Violet See AV-17 16-Pin Connector
Chart (Chime Warning).
Orange See following text (AV-17
Voice Warning output).