Electronic Systems Support EFR53 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 4 / 19

MNL-001600
Rev A
www.ess.to
November 2017 2
1. INTRODUCTION
ESS Front Terminal Battery Racks are shipped partially assembled, internally pre-wired and come with an
optional over current breaker. Refer to the battery rack's layout drawings and schematics at the end of this
manual. Consult the battery manufacturer’s battery operation and maintenance manual for complete
instructions.
These battery systems are Hi-Pot tested to UL 1778 standards at the factory prior to shipment. All system
settings are also adjusted at this time according to the specification sheet. Sales support for future equipment
or upgrades is provided by our sales staff and qualified representatives. All technical questions and service
issues should be directed to our office 972-272-2468.
2. PRECAUTIONS
It is very important to read, understand and follow the instructions in this manual. Also note all
SAFETY PRECAUTIONS before beginning the installation of this system.
Consult the Battery Manufacturer's Operation and Maintenance Manual for important battery
information.
Battery rack systems are very heavy. Total weight can exceed 7,000 lbs while single cabinets can
weigh up to 4,000 lbs. Use at least 3 people when unloading and setting equipment in place.
It is imperative that only qualified personnel work on this system and installation, maintenance or
upgrades be performed with insulated tools and equipment.
When installing this battery system, follow all applicable federal, state and local regulations and
industry guidelines to insure a proper installation.
DC power and battery supplies are dangerous and have extremely high short circuit currents.
Severe burns or death can result from a system short. They also can leak potentially explosive gas
(hydrogen). Never enclose batteries or battery racks in a sealed air tight room.
All jewelry and watches must be removed prior to installing or servicing this system.
Do not smoke or present flame near or around any battery rack system.
Never leave a panel off or door open and unattended.
3. INSPECTION UPON RECEIPT OF GOODS
3.1 General
Special precautions and care have been taken to ensure the rack system arrives safe and undamaged.
However, upon receipt, you should inspect the entire shipment, including the crate and any boxes for
evidence of damage that may have occurred during transit.