5
Electrolux Customer Service Helpline 1-800-896-9756
ENG
L
ISH
Vac & Steam special features
Caring for your Vac & Steam
Unplug and allow Vac & Steam to cool.
Slide dust cup latch left, to ‘unlock’ position (Fig. 3).
Remove dust cup. Twist top of dust cup to lift out screen.
Empty debris from dust cup (Fig. 4).
Remove sponge filter from top of screen. Wash sponge,
screen and dust cup in warm water. Allow to dry before
reassembling (Fig. 5).
Remove cleaning pad after use. Allow Vac & Steam to cool
completely, then step on pad lip and lift off Vac & Steam
(Fig. 6).
Wrap power cord and store Vac & Steam in upright
position.
Wash cleaning pads in warm water, by hand or machine.
Do not use fabric softener. Lay flat to dry.
Fig.5
Fig. 6
Fig. 3
Fig. 4
Fig. 1
Fig. 2
Clean burst pedal
A special ‘clean burst’ feature provides a focused burst of
steam for spot cleaning difficult-to-remove soil.
To use the clean burst feature:
It is recommended to turn vacuum off; use steam feature
only for best performance.
Press clean burst pedal to ‘spot clean’ position for five to
10 seconds. Allow steam burst to spray onto dried spills or
spots (Fig. 1).
Move floor nozzle back and forth to clean soiled area (Fig. 2).
Return pedal to ‘floor mop’ position after using clean burst.
N O T I C E
The steam feature can kill dust mites and some types of
bacteria when used properly. To disinfect a specific area, turn
steam on and position Vac & Steam over the area for a
minimum of eight seconds. This allows the floor under the
steamer to reach approximately 170
o
F. Use this procedure
to disinfect floors in bathrooms, pet sleeping quarters, etc.
87909rev2_VacSteam.qxp:English 10/15/13 3:08 PM Page 7