g
6
g
Dear Customer,
Please read these operating instruc-
tions carefully. Above all please
observe the safety information on the
first pages of these operating instruc-
tions! Please keep these operating
instructions for later reference. Pass
them on to any subsequent owner of
the appliance.
Description of the Appliance
1
Dust container
2
Dust filter
3
Release button
4
On/off switch
5
Charge control display
6
Charge socket
7
Wall mounting
8
Charger
9
Jack plug
10
Fold-down crevice nozzle
1
Safety Instructions
• Do not vacuum wet surfaces
• Do not use the vacuum cleaner on sur-
faces that have been treated with
flammable solvents until they are com-
pletely dry.
• Do not use your vacuum cleaner to
vacuum hot items such as a glowing
cigarette end.
• Never use the vacuum cleaner to pick
up combustible dust.
• Under no circumstances should you oil
or grease the motor.
• Do not expose the vacuum cleaner to
direct sunlight or any source of heat.
• For maintenance and repair please
contact your local dealer or authorised
service personnel. Never attempt to
carry out repairs to the vacuum cleaner
yourself.
• Only use the appropriate original
charging devices for this model.
;
This appliance complies with the fol-
lowing EC directives:
– 73/23/EWG dated 19.02.1973 “Low
Voltage Directive“, including Direc-
tive Amendment 93/68/EWG
– 89/336/EWG dated 03.05.1989 “EMC
Directive“, including Amendment
Directive 92/31/EWG
Prior to using for the first time
Before using your vacuum cleaner
for the first time you should charge
the battery for approx. 16-18 hours.
With a fully-charged battery you can
vacuum for approx. 8 minutes.
Attaching the Wall Mounting
(Fig. A)
Select a position near a room socket to
attach the wall mounting.
0
Hold the mounting against the wall
and mark the points for the fastening
screws.
0
Use a drill to drill the holes for the
screws and push in the plastic plugs
provided.
0
Position the wall mounting and then
insert the screws.
0
Then lower the wall mounting and
tighten the screws.
Charging (Fig. B)
The charger (8) may only be connected
to a power source of 230V, 50Hz.
0
Insert the vacuum cleaner into the wall
mounting (7) and check that the jack
plug (9) on the wall mounting fits cor-
rectly into the charge socket (6) on the
vacuum cleaner.
3
The charge control display (5) will
come on and charging will begin. It will
also come on if the battery is already
fully charged. Always leave your vac-
uum cleaner in the wall mounting
when not in use in order to guarantee
optimal suction power.
ZB_230.book Seite 6 Donnerstag, 10. August 2000 9:50 09
