Electrolux Side by Side Refrigerator, Инструкция по использованию и уходу

Страница: 10 / 159

10
TURNING THE COOLING SYSTEM ON AND OFF
You can disable the cooling system in your refrigerator by
pressing the
On/Off button located on the left side of the
temperature control panel. To ensure that you do not
accidentally turn off the cooling system, the button does not
work unless you press
and hold it for three seconds. Once
you disable the cooling system, all refrigeration to the freezer
and fresh food compartments stops. To turn the cooling
system back on, you must again press
and hold the On/Off
button for three more seconds.
Cooling System On/Off Button
Once you disable the alarm system, you must again press and
hold the Alarm Reset button for three more seconds to reset
(activate) the alarm system.
The On indicator light remains off while the freezer and
refrigerator compartments cool toward the current cooling
settings. When temperature settings are reached, the
On light
displays green to indicate an active alarm system.
RESPONDING TO ALARMS (Audible Tones & Indicator
Lights)
Your refrigerator’s control system can convey the following
information through audible tones and the alarm indicator
lights.
Alarm Reset Button Indicator Lights
ELECTRONIC TEMPERATURE CONTROLS
NO NO NO NO NOTE TE TE TE TE
Pressing the On/Off button on the control panel disables
your refrigerator’s cooling system but does not disconnect
power to lights and other electrical components. To turn off
power to your refrigerator you must unplug the power cord
from the wall outlet.
NO NO
NO NO
NOTE TE
TE TE
TE
Each time you make settings on the control panel, a single
audible tone acknowledges your input.
SYSTEM MONITORING ALARMS (Select Models)
The electronic control system continuously monitors your
refrigerator/freezer for temperature consistency, doors left
ajar, and power failures. Variances from normal operating
conditions are communicated by audible tones and a set of
four status indicator lights.
USING THE ALARM RESET BUTTON
You can disable or activate the alarm system by pressing and
holding the Reset button for three seconds. Use it, for
example, to turn off audible tones and/or flashing indicator
lights.
CA CA CA CA CAUTION UTION UTION UTION UTION
The alarm system does not automatically reset if you
disconnect and reconnect your refrigerator’s power cord.
It can only be reactivated by pressing the Alarm Reset
button.
Alarm
Name Indicator
Light
Audible
Tones Condition How To Respond
On Light is
off
Alarm system is
not active while
freezer and
refrigerator
compartments
are cooling
toward the
current
temperature
settings.
If freezer and refrigerator
compartments do not match
your temperature settings in
three hours, expect the
control system to signal
other conditions. If cooling
does not stabilize toward
your current settings call for
assistance, using the phone
number on the back page of
this Use & Care Guide .
Steady
Green
Alarm system is
active.
No response required.
Door
Ajar
Flashing
Green
9
Freezer or
refrigerator door
has been open
for over five
minutes.
Close door to disable and
reset alarm.
High
Temp
Flashing
Amber
9
Freezer or
refrigerator
compartment
has been too
warm (45
°
F or
higher) for over
an hour.
Press Alarm Reset button to
turn off alarm. If
temperatures do not
improve, call for assistance,
using the phone number on
the back page of this Use &
Care Guide .
Power
Failure
Flashing
Amber
A power outage
was detected.
Press Alarm Reset button to
turn off alarm and press
again to reset. Check if the
power failure lasted long
enough to affect stored food
temperatures.