Electrolux PA21G, Инструкция по эксплуатации, Страница: 7 / 17

6
IMPORTANT
Make sure that the water supply is closed
in order to prevent leakage.
Press the
cover
Open the
cover
Figure 4 Figure 5
Figure 6
ATTENTION
If the inlet pressure of the mains water is
low during the removal of water from the
product, interruptions in the water supply
may occur until the internal tank is refilled
again by the filter. In this case, you may re -
locate the product (to a place of higher wa-
ter pressure) or install a water pressurizer.
1. Connect the 3/4" adapter to the water supply
tap (Figure 1).
2. Attach the hose all the way into the adapter
(Figure 1).
Water supply
Hose
3/4”
adapter
Tap
Figure 1
IMPORTANT
Make sure there is no leakage in the hose
connections.
To prevent leakage, use sealing tape on
the connections when necessary.
3. Push the tab of the water connection and
remove the protection from the water inlet
(Figure 2).
water inlet protection
Figure 2
Figure 3
4. Fit the water inlet hose into the connection
and push it all the way to the end (Figure 3).
Filter Installation
1. Press the appliance cover to open it. (Figure
4)
2. Open the appliance cover. (Figure 5)
3. Take the filter out of the packaging.
4. With the product turned on, connect the filter
to the product and screw in the direction indi-
cated until it is aligned with the arrow to lock
it (Figure 6).
5. Open the water supply so that the product
starts to be filled.
6. Press and hold the “RESET FILTER” button
for 3 seconds.