28
The drain filter
Clean the filter at the bottom of the washing ma-
chine regularly. If your washing fluffs a lot, clean the
filter after every wash. Lower the drain pipe into a
large receptacle placed on the floor to drain any
water remaining in your washing machine and then:
to drain all remaining water:
a. Open the chute (fig. 1)
b. Place a shallow receptacle with a straight edge
under the chute. To finish draining, turn the drain
filter plug until it is vertical to allow all remaining
water to run out (fig. 2).
to clean the filter:
a. Turn the filter in the anti-clockwise direction and
take it out (fig. 3).
b. Clean it carefully with running water.
c. Put the filter back in position and screw it in the
clockwise direction.
d. Close the chute again.
Precautions against frost
If your appliance is exposed at a temperature lower than 0° C, take the
following precautions:
- Switch off the water inlet tap and the water inlet pipe.
- Place the end of this pipe and this one of the drain pipe in a basin on
the ground.
- Select the drain programme "
".
- Switch off the appliance by placing the selector programme on the OFF
position " ".
- Unplug the appliance.
- Rescrew the water inlet pipe and replace the drain pipe.
In this way, the water remained in the pipes is drained. So frost can not
damage your appliance.
For the future uses of your appliance, make sure that the temperature of
the room where is located the machine is upper than 0° C.
.
User's instructions
.
Fig.1
Fig.2
Fig.3
