Fig. 7a
Turn the stabiliser valve
spindle fully clockwise
until resistance is felt.
1.
Stabiliser valve
Water flow position
2. Adjust the spline spindle and the control
knob to the correct position before replacing
the cover Fig. 7a, 7b show the correct pline
spindle and the control knob position.
1. Before fixing the front cover to the shower,
tighten the 3 screws to fix the shower on the
wall firmly.
3. Reassemble the water inlet cover Fig. 8a
and reconnect the cable Fig. 8b.
4. Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
spindles. Should any difficulty arise, recheck
the points above.
5. While applying slight pressure to the cover,
secure in position with the retaining screws.
6. Once you place the front cover on the
back cover properly fix the front cover with
the 4 screws.
5.4
Fixing the front cover
15
ENGLISH
Fig. 8a
Fig. 8b
Fig. 7b
Turn the water flow
controler fully clockwise
to the Minimum
2.
