13
ENGLISH
To remove the water inlet cover
To change the water inlet position
The factory default setting of the water inlet
position is on the right side. To change the
water inlet position just remove the terminal
block from the left side and put it on the
right side. When you remove the terminal
block, you need to pull out the steel
fastening strip first and fix it on the terminal
block again when you put the terminal block
on the right side. After that try to pull the
terminal block out to check if it is fixed.
Fig. 4a
Fig. 4.
5.2
Plumbing connection
To remove the front cover
Hook the backplate over the top screw and
fit the bottom screws into position, but
DO NOT fully tighten the screws at this stage.
The fixing holes are elongated to allow for
out of square adjustment after the plumbing
connection has been completed.
Unscrew the water inlet cover fixing screws
and pull the water inlet cover out Fig. 4.
Unscrew the screws that fixing the front
cover (Fig. 2a), and pull out the front cover
lightly, then disconnect the cable between
front cover and the chassis (Fig. 2b), after
that remove the front cover.
Fig. 2a
Fig. 2b
NOTE:
The knobs and On/off button are
fixed on the front cover. Do not try to
remove them.
According to the water and cable entry point
you selected, cut out the trim plate on the
chassis. To do that you may need a pair of
pincers. See Fig. 3 for the location of the
trim plate.
To remove the entry point trim plate
Fig. 3
Water Pipe entry points trimplate
Water Pipe entry points trimplate
Cable entry points
Cable entry points
Fig. 4b
Terminal block
