SOI/DT 2007-02 dmm
17/66
599 38 61-92
4.2.7
Stop or cancelation of a programme
When the washing programme has already begun.
The user can stop it or cancel it by turning the
programme selector to position 0 (zero, appliance off).
When the user switches the appliance on again, s/he
will be required to confirm the cancellation or to
continue the programme.
To cancel the programme, the user must push the
button OK (5).
To continue the programme, the user must push the
button START/PAUSE (6) and the cycle will start from
the point at which it was interrupted.
4.2.8
End of cycle
When the washing cycle has terminated also all the
animations terminate and a text is shown to inform the user
that the cycle has finished.
Simultaneously a melody starts (to inform that the cycle is
finished). In the beginning it is quite frequent, then it
becomes less frequent (for a max. time of 3 minutes).
After some seconds the display shows that the open can be
opened.
The user can deactivate the melody by turning the programme selector to position 0 (zero).
4.2.8.1 Stand-by
If the user does not push any button or does not turn the selector knob while the appliance is in selection mode
or at the end of the washing cycle, the appliance is in STAND-BY after ten minutes. The LED of the
START/PAUSE button flashes slowly, the light of the LCD display switches off, the symbols and the digits
remain visible, the door interlock and the Inverter board are not powered.
The Delayed start phase is considered an active phase therefore the STAND-BY is not active.
When the user pushes a button, the appliance exits from the STAND-BY condition.
