Electrolux EWM 1046 EEU, Руководство пользователя

Страница: 22 / 24

Problem Possible solution
Make sure that the packaging and/or the transit bolts are
removed. Refer to 'Installation'.
Add more laundry in the drum. The load may be too
small.
The appliance fills with
water and drain imme-
diately. Make sure that the drain hose is in the correct position.
The hose may be too low.
The washing results
are not satisfactory. Increase the detergent quantity or use a different deter-
gent.
Use special products to remove the stubborn stains be-
fore you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Service. If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
13. TECHNICAL DATA
Dimensions Width / Height / Depth 595 / 850 / 380 mm
Total depth 420 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency 230 V
2000 W
10 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture IPX4
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply
1) Cold water
Maximum load Cotton 4 kg
Spin speed Maximum 1000 rpm
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
22 www.electrolux.com