Electrolux EWG 147540 W, Руководство пользователя

Страница: 25 / 36

2. Connect the hose with the angled con-
nection to the machine. Do not place
the inlet hose downwards. Angle the
hose to the left or right depending on
the position of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this type
of use.
WATER-STOP DEVICE
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window
«A» . Should this occur, turn the
45°
35°
water tap off and refer to your Service Cen-
tre to replace the hose.
A
Warning! Installation should
comply with local water authority
and building regulations’
requirements.
The appliance must be connected
to a cold water supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe oper-
ation of the appliance.
If you cannot make the cold water con-
nection direct from the rising mains,
you may be able to operate the appli-
ance from your cold water storage sys-
tem.
There should be a minimum vertical
distance of 5.02 m (16.5 ft) between
the appliance’s inlet and the bottom of
the water storage tank.
WATER DRAINAGE
This appliance is designed to be perma-
nently plumbed into your home's drainage
system using one of the following methods.
1. Into a drainage standpipe
Firstly form a hook in the end of the drain
hose using the “U” piece” supplied.
“U” piece
supplied
electrolux 25