9
Press these buttons to select the following options:
1.Prewash:
Select this option if you wish your laundry
to be prewashed before the main wash (not
available for wool ,handwash ,mini programme and
silk programmes.)
The Prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
2.Extra Rinse:
This option can be selected with all
programmes, except the wool and handwash
programme. The machine will add 2 rinses for
cottons and 1 rinse for synthetics, delicates and silk
programme.This option is recommended for people
who are allergic to detergents, and in areas where
the water is very soft.
3 Night Cycle:
This option can be selected with all
programmes. It eliminates all spin phases of the
cycle, increasing the number of rinses, stops the
cycle before final spin with water in the drum,
eleminating the buzzer signal.To continue, it is
necessory to select a drain or spin cycle.
4.Time Save:
This option can be used for lightly soiled
(not for wool, hand wash, silk and miniprogramme)
in order to obtain a good washing programme in a
short time. The washing time will be reduced
according to the type of fabric .
6. Start/ Add Clothes Button
This button has 2 functions:
Start:
after you have selected the desired programme and
options, press this button to start the washing
machine. The light close to the button will stop
flashing and remain lit.
Add Clothes:
When you press this button again, the programme in
progress is interrupted. The light close to the button
will start flashing. To restart the programme, press
the button again. When you press “Add Clothes”, it
becomes possible to open the door if:
The washing machine is not in the heating phase;
The level of the water is not high;
The drum is not turning.
Important!
You must pause the washing machine
before you make any change in the programme in
progress, by pressing “START/ Add Clothes” button.
7. Programme Phase indicator
Light
By selecting the wash programme, the LED
corresponding to the various phases making up the
programme lights.
After you have started the programme, only the LED
relevant to the phase that is currently being carried
out will remain lit.
At the end of the programme the “End” LED
illuminates.
im_ewf890_eu-ok.qxd 7-09-2005 15:05 Pagina 9
