Electrolux EWF 1480, Информация пользователя

Страница: 38 / 48

38
Setting Up on a Concrete Pedestal
When setting up the washing machine on a concrete
pedestal, it is essential for safety reasons to fit stand
plates in which the washing machine is then
adjusted. The stand plates are available from the
Customer Service Centre.
Setting Up on a Vibrating floor
In the case of vibrating floors, especially wooden
beam floors with flexible boards, securely screw a
water-resistant wooden panel at least 15mm thick
onto at least 2 of the floor beams. If possible, set up
the unit in a corner of the room where the wooden
floor is best firmly installed and is therefore least
likely to be susceptible to vibrations.
Compensate for Floor Unevenness
Floor unevenness can be compensated for and the
height can be corrected with the four adjustable
screw feet. The height can be adjusted in a range of
+10 ... -5 mm.
To adjust the feet use the special spanner supplied
for removing the transport braces.
1. Slide the special key firmly onto the hexagon
head of the threaded foot as far as it will go.
2. Adjust the screw feet so that the unit is horizontal
and stable. The unit must not wobble over when
loaded.
3. If necessary, check the setting with a spirit level.
Attention! Never compensate for minor floor une-
venness with underlays made of wood, card etc.
Always adjust the adjustable feet.