Electrolux EWF 1480, Информация пользователя

Страница: 27 / 48

27
The washing solution of the
main wash froths up a lot. Too much detergent was probably
used
Meter the detergent exactly in
accordance with the manufacturer's
information.
Water runs out under the
washing machine.
The screw connection on the intake
hose is leaky. Tighten the intake hose screw con-
nection
The drainage hose is leaky.
Check the drainage hose and replace
it if necessary.
The drain pump cover is not correctly
closed.
Close cover correctly.
Washing stuck in the filling door.
Abort the program, remove washing
from the door and start a new pro-
gram.
The emergency drain hose is not
properly shut off or it is not water-
tight.
Shut the emergency drain hose off
properly (see section "Carry Out
Emergency Emptying"). Call your
after-sales service if the emergency
drain hose is not water-tight.
The drain pump for the wash-
ing machine runs constantly
- even when the appliance is
switched off.
The Aqua Control anti-flood system
has been activated.
Turn off the tap, then remove the plug
from the mains and inform Customer
Service.
Conditioner not added, com-
partment æ for care agent full
of water. Filter insert in the compartment for
care agent not correctly attached or is
blocked.
Clean the detergent drawer and firmly
attach the filter insert.
Washing heavily creased Too mush washing probably put in.
Pay attention to the maximum filling
quantity (see Program tables). For
easy-care textiles, select the program
EASY IRON (Leichtbügeln, Fâcile à
Repasser).
Washing not well spun. Resid-
ual water still visible in the
drum.
Fault code
(2 appears.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet head
1m from unit's floor surface)
exceeded.
Consult Customer Service. They can
supply a retrofit kit as a special
accessory for delivery heads of more
than 1m.
Drain pump blocked.
Switch off the unit and pull out the
mains plug. Clean the drain pump.
If a siphon is connected: Siphon
blocked.
Clean the siphon.
The filling door cannot be
opened with the unit switched
on.
Door locked for safety reasons, dis-
play DOOR (Tür, Porte) is off. Wait until the display DOOR (Tür,
Porte) lights up green.
The program saving function is set.
Cancel the program saving function
(see section ”Program saving”).
Washing detergent residues
form in the washing detergent
drawer.
Water tap not fully opened. Open the water tap fully.
Filter in the screw connection of the
intake hose on the water tap or on the
unit is blocked. Close the water tap. Unscrew the
intake hose from the water tap and
from the unit and clean the filter.
The rinsing water is murky.
The cause is probably a detergent
with a high silicate content.
No negative influence on the rinsing
result, possibly use liquid detergent if
necessary.
Problem Possible Cause Remedy