In this fully integrated appliance the controls are located on the
top of the door. When selecting a programme, the door needs to
be open.
1. Check that the baskets have been
loaded correctly and that the spray
arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
The indicator lights of the programme selection buttons
illuminate.
4. Setting and starting the programme
To select a programme, press the button of the programme
you wish to select (see "Washing programmes" chart).
The corresponding indicator light remains illuminated while
the other programme buttons indicator lights turn off.
In the digital display will appear, flashing, the running time
(in minutes) of the programme that has been set.
Close the dishwasher’s door, the programme will start
automatically.
Setting and starting the programme with the
delay start
Once the washing programme has been selected press the
Delay Start button, the corresponding indicator light will
illuminate and 1h appears in the digital display.
Press the delay start button until the number of hours desired
(from 1 hour up to 19 hours) appear in the digital display.
Close the dishwasher door, the countdown starts
automatically and will decrease with steps of 1 hour.
The opening of the door will not modify or interrupt the
countdown.
Once the delay start has elapsed the washing programme
will start automatically.
NOTE:
The start of the programme or the countdown of the
delay start will occur only after the closure of the door, until
this moment it is possible to modify the set made.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in progress
ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is opened.
Open the door carefully.
Interrupt a washing programme in progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point at
which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously function buttons 2 and 3 for about 2
seconds, the indicator light of the button corresponding to
the running programme starts flashing. After about 2
seconds the indicator lights of all the programme selection
buttons will illuminate, this means that the running
programme has been cancelled and that the machine has
returned to setting mode.
If a new washing programme is to be selected, check that
there is detergent in the detergent dispenser.
6. To cancel a delay start in progress
To cancel a delay start in progress you have to reset the
dishwasher; follow the same instructions given in "Cancel
a washing programme in progress". Cancelling a delay
start involves also the cancelling of the set washing
programme.
In this case you have to set the washing programme again.
7. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
Open the dishwasher’s door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will be
cooler and the drying will be improved.
In the digital display appears 0, only in this case the
programme has ended.
Switch off the dishwasher by pressing the On/Off button.
8. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should
therefore be allowed to cool down before removing from
the appliance.
Empty the lower basket first and then the upper one; this
will avoid water dripping from the upper basket onto the
dishes in the lower one.
Water may appear on the sides and the door of the
dishwasher as the stainless steel will eventually become
cooler than the dishes.
When the washing programme has finished, it is
recommended that the dishwasher is unplugged and the
water tap turned off.
Starting a Washing Programme
12
Содержание ESL 6163
Страница 1: ...USE CARE MANUAL ESL 6163 ...
