25
Fitting a unit door
• Slide the fitting aids
➍
up
level with the unit door:
underside of stop edge of
fitting aid = upper edge of
unit door.
• Unscrew the counternuts
➌
.
• Attach bracket
➎
to hous-
ing unit door with 4 x 14
wood board screws
➐
.
• Loosen the cross-headed
screws
➏
.
• Align housing unit door
parallel to appliance door.
Tighten M6 screws
➏
.
• Close the door and check
distance between door
and surrounding housing
unit doors.
• Suspend the attachment
strut
➊
on the unit door.
Depending on the width of
the recess, the middle line
of the attachment strut will
have to be moved towards
the hinge!
• Fasten the attachment
strut
➊
: With at least 6
screws (4x14) if the doors
are made of wood board.
With 4 screws round the edge in the case of panel doors.
• Lift the fitting aids
➍
out to the top, turn round and insert into
the adjacent openings.
• Suspend the unit door on
the door of the appliance/
adjusting pins
➋
. Screw
the counternuts
➌
loosely
onto the adjusting pins.
• Align the unit door flush
with the surrounding unit
fronts: align laaterally
X
by
sliding in the correspond-
ing direction, adjust height
Y
and lateral tilt with the
adjusting pins
➋
with a
screwdriver. Tighten coun-
ternuts
➌
.
• Adjust the depth of the unit door
Z
: loosen the cross-headed
screws
➑
.
• Cover the attachment
brackets with the cover
strip
BO
and click into
place.
• Click cover
BS
into place.
Fasten the appliance in the recess
ERO 3298
• with the attachment profile
bm
at the top, fig.
B1
,
• with the hinges at the side, fig.
B2
,
• with the attachment element
bl
at the bottom, fig.
B3
.
IK 319
• with the attachment profile
bm
at the top, fig.
B1
,
• with the hinges at the side, fig.
B2
,
• with the attachment element
9
at the bottom, fig.
B4
.
GB
