Electrolux EMG25D89GGP, Инструкция по установке и эксплуатации

Страница: 7 / 40

6
30cm
7.5cm
INSTALLATION OF EMM25D89GGP
CAUTION!
1.Do not block the air vents. If you do that, the appliance
can overheat.
2.Do not connect the appliance to adapters or extension
leads.This can cause overloading and risk of fire.
• Put the appliance far away from steam, hot air and
water splashes.
• If the appliance is stored/ transported at sub-zero
temperatures, do not activate it immediately after
installation. Allow at least two hours for it to be brought
up to room temperature before turning on the unit.
Installation
• Remove all packing material and any promotional
material from the microwave oven.
• Examine the oven for any damage such as dents or a
broken door. Do not install if the oven is damaged. Call
the service centre.
• Remove the protective film on the oven cabinet
surface. Do not remove the light brown Mica cover
that is attached to the right-hand side of the oven
cavity to protect the magnetron.
• Do not leave the packing material so that small
children can play with it. This can be hazardous.
• Select a flat, level surface that provides enough open
space for the intake and outlet vents and that is strong
enough to bear the weight of the oven. A minimum
clearance of 7.5cm is required between the oven and
any adjacent walls. Leave a minimum clearance 30cm
above the oven.
- 7.5cm
WARNING!
If installed near or over a heat source, the
microwave oven could be damaged.
WARNING!
This microwave oven must not be used
on a non-earth protected power supply.
Contact an electrician if you are uncertain
regarding electrical connection of the
oven or provision of earth protection of
the supply.
WARNING!
If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
Min. 85 cm from
floor to base of
microwave oven.
Blocking the intake or outlet vents can damage
the oven. If air vents are blocked during
operation, the oven may overheat, and this may
lead to malfunctioning. Hot air escapes from the
vents, so be sure not to obstruct it or let curtains
come between the oven and the rear wall.
NOTE: It is recommended to have greater than
7.5cm clearance on at least one of the sides to
improve product performance and operation.
he oven should be placed in a stable position to
avoid the possibility of causing vibration or noise.
• Do not remove the legs from the bottom of the
oven.
• This oven should only be installed freestanding;
not built-in or in a cabinet.
• Keep the oven away from heat and water.
Exposure to heat and water can lower the
efficiency and lead to malfunctioning.
• Place the oven as far away from radios and TV
as possible. Operation of the oven may cause
interference to your radio or TV reception.
• When there is interference, it may be reduced
or eliminated by taking the following measures:
-Clean door and sealing surface of the
microwave oven.
-Reorient the receiving antenna of the radio
and/or television.
-Move the microwave oven away from the
receiver.
-Plug the microwave oven into a different outlet
so that microwave oven and receiver are on
different branch circuits.
• Be sure the voltage and frequency where you
connect the microwave oven is the same as
speci fied on t he rating plate on the microwave
oven. If the microwave oven is connected to the
socket via an extension cord, make sure the cord
is earthed.