Electrolux EL8600 Series Скачать руководство пользователя страница 5

Страница: 5 / 6

D. Front Housing Assembly Removal / Installation

• Remove the Dust Cup

• Remove 7x T-20 screws from front housing assembly

• Remove the Beauty Ring Front Fascia by carefully prying to disengage clip (Picture D.1)

• Remove 2x T-20 screws holding the Beauty Ring Rear Fascia to the body (Picture D.2)

• Starting where the last screws were removed work up the side where the front and rear

housings join. There are clips holding the housings together that need to be disengaged

before removing the front housing (Picture D.3)

• You may need to use two flat head screwdrivers, putty knives, etc. to work up the seam.

Pictures D.4 and D.5 show the clips in more detail

• Reassemble in reverse order

Picture D.1

Picture D.2

Picture D.3

Picture D.4

Содержание EL8600 Series

Страница 1: ...Page 3 Brushroll Motor Drive Assembly Section C Page 4 Front Housing Section D Page 5 Suction Motor Section E Page 6 1 Tools Required Saftey Glasses Clean Pad or Soft Cloth to prevent scratching of plastic parts during repair Phillips Head Screwdriver Flathead Screwdriver Torx 20 Screwdriver Torx 10 Screwdriver ...

Страница 3: ...e on left side while facing the unit to release hood clip Picture B 1 Press in on front snaps to disengage from base Picture B 2 While pulling the handle release pedal back lift upwards on the hood until the snap disengages from the right side Picture B 3 Reassemble in reverse order Picture C 1 Picture C 2 Picture C 3 3 ...

Страница 4: ... Disconnect the positive and negative terminals from the motor Picture C 2 Remove 1x T 20 screw from the Drive Assembly Picture C 1 Lift the Drive assembly out of base and use flathead screwdriver to disengage the four clips which hold the cover in place Picture C 3 Now belt is accessible for replacement Reassemble in reverse order Picture C 1 Picture C 2 Picture C 3 ...

Страница 6: ...move 3x T 20 screws from beneath the HEPA filter Picture E 1 Remove 3x T 20 screws from front of motor housing you will need to tilt the handle back in order to access the screws Picture E 2 Remove the Front Motor Cover to access the motor Reassemble in reverse order Picture E 1 Picture E 2 6 ...