Electrolux EIFLW55H MB, Техническое и сервисное руководство

Страница: 74 / 90

Component Teardown
4-14
Detergent Cavity Assembly Removal
The detergent cavity assembly is secured to the top
brace with two screws and is supported by a tab that
slides under a lip formed on the assembly. The assembly
is also secured to the control console with two screws
behind the detergent drawer.
To remove the detergent cavity dispenser:
1. Remove detergent drawer.
2. Using a #2 square bit screwdriver, extract the two
screws securing the detergent cavity dispenser to
the console. (See Figure 4-38)
3. Remove top panel.
4. Remove water inlet valve assembly and overflow/
vent tube.
5. Using a #2 square bit screwdriver, disconnect
detergent dispenser outlet hose. (See Figure 4-41)
6. Extract the two screws securing the detergent
cavity dispenser to the center brace.
(See Figure 4-39)
7. Release the (2) retaining latches, one on each side,
locking the housing to the console mounting panel.
(See Figure 4-39)
8. Slide the housing back until the tab of the top center
brace release and the housing drops down.
(See Figure 4-39)
9. Using a pliers, disconnect the advanced rinsing
technology hose. (See Figure 4-40)
10. Push down on the tub and swing the front of the
housing toward the center of the washer. Work the
housing out from under the center brace and lift the
housing out.
Detergent Dispenser Outlet Hose Removal
The detergent dispenser outlet hose is secured to the
bottom of the detergent dispenser and to the side of the
wash tub with hose clamps.
To remove the detergent dispenser outlet hose:
1. Remove the top panel.
2. Release the overflow/vent tube and slide it back.
3. Using a #2 square bit screwdriver, loosen the (2)
clamps, one on each end, and slide the hose off.
(See Figure 4-41)
Figure 4-38.
Figure 4-39.
Figure 4-41.
Screws
Tab
Retaining
Latches
Screws
Figure 4-40.
Hose Clamps
Front Frame
ART Hose To Bellows
Hose Clamp
Bottom of
Detergent
Dispenser