Electrolux EIFLW55H MB, Техническое и сервисное руководство

Страница: 62 / 90

4-2
Component Teardown
This section will describe how to remove serviceable
components from the washer. Unless stated, the
procedure will be the same on all models. Unless stated,
reverse the procedure to reinstall the component.
Door Trim Ring Removal
The door is secured to a hinge assembly mounted to the
unit frame. The trim ring must be removed to access and
remove the hinge assembly.
To remove the door trim ring:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract and save
the trim plug and long course thread, panhead
screw. (See Figure 4-1)
3. Close the door.
4. Rotate the door trim approximately ¾” counter-
clockwise and pull it away from the front of the door.
(See Figure 4-2)
Door Assembly Removal
The door assembly is secured with 4 screws to the hinge
assembly. It is not necessary to remove the trim ring to
access the hinge screws of the door assembly.
To remove the door assembly:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract the 4 long,
course thread, countersunk hinge screws from door.
(See Figure 4-3)
3. While supporting the weight of the door with both
hands, separate the door from the hinge.
(See Figure 4-4)
4. Gently place the door face down on a flat, covered
work surface.
Figure 4-1.
Figure 4-2.
Figure 4-3.
Figure 4-4.
Trim Plug
Trim Ring
Door Hinge Screws