Electrolux EI30BM55HB - 30" Microwave Oven, Техническое и сервисное руководство

Страница: 49 / 60

Component Teardown
4-11
Positive Lock ® Connector (No-
Case Type) Removal
1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for
60 seconds.
4. Push the lever of positive lock ® connector.
5. Pull down on the positive lock ® connector.
Oven Lamp Removal
1. Disconnect the power supply cord.
2. Remove the hood louver from the oven. (Refer to
procedure of “HOOD LOUVER REMOVAL”)
3. Lift the oven lamp cover up.
4. Now, the oven lamp and the socket are found.
5. Screw the oven lamp off from the lamp socket.
6. Now, the oven lamp is free.
Cook Top Lamp Socket
1. Disconnect the power supply cord.
2. Remove the three (3) screws holding the
deflector to the base cover.
3. Remove the four (4) screws holding the base
cover to the oven cavity.
4. Pull down and slide to left the base cover. And
remove the base cover from the cavity back plate.
5. Remove the one (1) screw holding the lamp
mounting angle.
6. Remove the lamp mounting angle from the oven
cavity face plate.
7. Disconnect the wire leads from the lamp socket.
8. Remove the two (2) screws holding the lamp
socket from the lamp mounting angle.
9. Now, the lamp socket is free.
Stirrer Antenna Motor Removal
1. Disconnect the power supply cord and remove
the oven from wall and remove outer case. (Refer
to procedure of "Removal of Oven from Wall" and
"Outer Case Removal")
2. Open the door and block it open.
3. To discharge the high voltage capacitor, wait for
60 seconds.
4. Remove the hood duct from the oven cavity, refer-
ring to the procedure of “HOOD FAN MOTOR,
HOOD DUCT AND OVEN LAMP
SOCKET REMOVAL”.
5. Disconnect the wire leads from the stirrer
antenna motor.
6. Remove the one (1) screw holding the stirrer
antenna motor to the waveguide of the oven
cavity.
7. Remove the stirrer antenna motor from the
waveguide.
8. Now, the stirrer antenna motor is free.
9. When installing the stirrer antenna motor, the
shaft of stirrer antenna motor must be inserted to
the stirrer antenna shaft. Refer to the procedure
of “STIRRER COVER AND STIRRER FAN
INSTALLATION”.
Terminal
Push
Pull down
1
2
Lever
Positive lock®
connector
CAUTION
When connecting the positive lock ® connectors
to the terminals, install the positive lock ® so
that the lever faces you.