Electrolux EHS 30020P, Руководство пользователя

Страница: 22 / 52

Problem Possible cause Remedy
The highest heat setting is set. The highest heat setting has the
same power as the Automatic
Heat Up function.
You decreased the heat setting
from
.
Start from and only increase
the heat setting.
You cannot activate the outer
ring. Activate the inner ring first.
The sensor fields become hot. The cookware is too large or
you put it too near to the con-
trols. Put large cookware on the rear
cooking zones if necessary.
comes on.
The Automatic Switch Off op-
erates. Deactivate the appliance and
activate it again.
comes on.
The Child Safety Device or the
Lock function operates. Refer to the chapter “Daily Use”.
and a number come on.
There is an error in the appli-
ance. Disconnect the appliance from
the electrical supply for some
time. Disconnect the fuse from
the electrical system of the
house. Connect it again. If
comes on again, speak to the
service centre.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the customer service. Give the data from
the rating plate, three digit letter code for
the glass ceramic (it is in the corner of the
glass surface) and an error message that
comes on. Make sure, you operated the appliance cor-
rectly. If not the servicing by a customer
service technician or dealer will not be free
of charge, also during the warranty period.
The instructions about the customer service
and conditions of guarantee are in the guar-
antee booklet.
INSTALLATION INSTRUCTIONS
Warning! Refer to the Safety chapters.
Before the installation
Before the installation of the appliance, re-
cord the information below from the rating
plate. The rating plate is on the bottom of
the appliance casing.
• Model ...........................
• PNC .............................
• Serial number ....................
BUILT-IN APPLIANCES
• Only use the built-in appliances after you
assemble the appliance into correct built-
in units and work surfaces that align to
the standards.
CONNECTION CABLE
• The appliance is supplied with the con-
nection cable.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C;
or higher). Speak to your local Service
Centre.
TO ATTACH THE SEAL.
• Clean the worktop in the area of the cut
out section.
• Bond the seal stripe supplied on the low-
er edge of the appliance along the outer
edge of the glass ceramic. Do not extend
it. Let stay the cut ends in the middle of
one side. When, you cut it to length (add
some mm), push the two ends together.
22 electrolux