13
Hob installation
D
Cut out the worktop acc. to prescribed cutout size.
The tolerance sizes must not be exceeded. Do
precisely saw at the mark line. Recommendation:
Mark the cutout with a steel needle. Glue some-
thing on the line in order to avoid shattering of the
coat when cutting.
D
With tile--coated worktop areas the slits in the
supporting area for the cooking area must be filled
up completely.
D
Clean the worktop in the cutout area
D
The cooking area is entered from the top into the
cut--out section, centered and firmly pressed on
until the springs will catch.
D
Check the sealing in the supporting frame for per-
fect seating and resting without a gap. Please do
not apply additional silicone sealing material, the
closure will make it harder to dismantle in case of
need for service.
D
4 holes in the bottom of the build--in case are pro-
vided for the screws of the fitting plates.
D
At first screw on the fitting plates by a screwdriver
and afterwards regularly tighten the plates alter-
natively and diagonally offset, until the frame of
the cooking area is perfectly laying on the work-
top.
D
Over--tightening must be avoided! Electric screw-
drivers or pusher airscrews to be exclusively used
with slip clutch (setting value 1 -- 1.1 Nm).
1
2
R5
frame
ceramic glass plate
fixing clamp
worktop
