Electrolux EGL4500X, Руководство пользователя

Страница: 16 / 28

UK
16
Installation
Side cooking surface gas connection
THE APPLIANCE IS ALREADY REGULATED TO OPERATE WITH LPG (G30/31 AT 28-30/37MBAR).
NEVER CONNECT THE PIPES DIRECTLY TO THE GAS BOTTLE: A PRESSURE REGULATOR MUST ALWAYS
BEEN INTERPOSED.
1) Unscrew the 4 screws A and remove the sheet B at the back of the barbecue.
2) The pipe G is provided already connected to the end N of the gas ramp of the hob. Route the pipe G
underneath the cooking surface. Insert the other end of the pipe G through the pre-cut holes L and F , then
connect it to the threaded union E .
3) Provide a gas pipe I of 1500 mm length. You may need a pipe holder H on the end of the ramp of the hob M .
4) Connect the end of the gas pipe I directly to the end of the hob ramp M or to the pipe holder H .
5) Route the pipe I underneath the cooking surface (outside as shown in the picture).
6) If the gas bottle is housed inside the trolley, use the pre-cut hole L to route the gas pipe I .
7) Connect the end of the gas pipe I to the gas pressure regulator C .
8) Connect the gas pressure regulator C to the threaded union D on the bottle.
9) After connecting, refit the rear sheet B .
.
The symbols in the picture mean that on those points a clamp could be necessary.
AFTER CONNECTING, ENSURE THE RUBBER PIPE IS NOT CRUSHED, HANGING OR OBSTRUCTING THE LID
OPENING.
Side cooking surface burner control knob
To switch on the burner refer to section "Lighting the burners" on page 22.
LPG
D
E
F
G
I
I
G
N
M
H
C
L
B
G
I
A