9
Changing the light bulb
•
Disconnect the cooker hood from the main
supply.
•
Open the lamp cover by pushing simultaneously
two unlocking button
R
.
Disengage the lamp cover from its hanging rails
(Fig. 5).
•
Replace the old light bulb(s) with a new light
bulb of the same kind.
•
Refit the lamp cover.
•
If the light does not come on, make sure the
bulb has been inserted correctly before
contacting your local Service Force Centre.
What to do if
If your appliance fails to work properly please carry out the following checks.
Symptom
Solution
The cooker hood will not start...
Check that: The hood is connected to the electricity supply.
Check that a fan speed has been selected
The cooker hood is not working
Check that: The fan speed is set high enough for the task.
The grease filters are clean.
The kitchen is adequately vented to allow the entry of fresh air.
If set up for recirculation, check that the charcoal filter is still effective.
If set up for extraction, check that the ducting and outlets are not
blocked.
The cooker hood has
The safety cut-out device has been tripped.
switched off during operation...
Turn off the hob and then wait for the device to reset.
If the hood has been installed below the heights indicated in the
installation instructions the motor will cut-out frequently which will
damage the hood.
If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and
serial number.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge
if the fault is not a mechanical or electrical breakdown.
Special Accessories
Charcoal filter Type 150 LONG LIFE
Available from your retailer as an accessory
Charcoal filter Type 150
Available from your retailer as an accessory
Finishing strip*
ET-NR.:
502 426 420 02
Clips for finishing strip (3x)*
ET-NR.:
502 302 940 06
* ET-NR. contact our Service Force Centre
Fig. 5
R
