Electrolux EFL716Y, Руководство пользователя

Страница: 4 / 160

www.electrolux.com 4
hood and fi lters will lead to the risk of fi res. The fl aming of foods beneath the
hood itself is severely prohibited. The use of exposed fl ames is detrimental
to the fi lters and may cause a fi re risk, and must therefore be avoided in all
circumstances.
Any frying must be done with care in order to make sure that the oil does not
overheat and ignite.
CAUTION: Accessible parts of the hood may become hot when used with
cooking appliances.
For lamp replacement use only lamp type indicated in the Maintenance/
Replacing lamps section of this manual.
WARNING! Do not connect the appliance to the mains until the installation
is fully complete.
When connecting the hood to the electrical network, only certifi ed electrical
adaptors are allowed and not power strips.
1. SAFETY INSTRUCTIONS
With regards to the technical and safety
measures to be adopted for fume discharging
it is important to closely follow the regulations
provided by the local authorities.
The ducting system for this appliance must
not be connected to any existing ventilation
system which is being used for any other
purpose such as discharging exhaust fumes
from appliances burning gas or other fuels.
Do not use or leave the hood without the
lamp correctly mounted due to the possible
risk of electric shocks. Never use the hood
without eff ectively mounted grids. The hood
must NEVER be used as a support surface
unless specifi cally indicated. Use only the
fi xing screws supplied with the product for
installation or, if not supplied, purchase the
correct screws type. Use the correct length
for the screws which are identifi ed in the
Installation Guide. In case of doubt, consult
an authorised service assistance centre or
similar qualifi ed person.
WARNING! Failure to install the screws
or fixing device in accordance with
these instructions may result in electrical
hazards.
2. USE
The hood serves to aspirate the fumes and
vapors resulting from cooking.
The attached installation manual indicates
the version to be used depending on the
model you have, the suction version with
external evacuation or fi ltering with internal
recirculation .
In some models ONLY:
As optional accessory is supplied a Non
return valve.
This should be installed inside the proper
outlet hole housing in same cases only (i.e:
in any case there's no protection against
accidental backdraft air current from the
outside).
3. INSTALLATION
The mains power supply must correspond
to the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it not
fi tted with a plug (direct mains connection)
or if the plug is not located in an accessible
area, after installation, apply a double
pole switch in accordance with standards
which assures the complete disconnection
of the mains under conditions relating to
over-current category III in accordance with
installation instructions.
Warning! Before re-connecting the hood
circuit to the mains supply and checking
the efficient function, always check that
the mains cable is correctly assembled.