29
7.
Unscrew cover plates E from the front of the ma-
chine, rotate through 180°, screw on the opposite
side.
8.
Unscrew door lock F, push down slightly and re-
move from the front of the machine.
9.
Disconnect cable connector from door lock F.
10.
Press snap-in button G in and down, press cover
down slightly and remove from front of the ma-
chine.
11.
Disconnect cable connector from cover G.
12.
Change door lock F over to the opposite side, in-
sert the cable connector and screw down the door
interlock.
13.
On the other side, insert the cable connector in
cover G, insert cover and allow snap-in button to
lock into place.
14.
Insert loading door and hinges into recesses on
the front of the machine and screw down.
15.
Once the door stop has been replaced, check the
function of the DOOR (TÜR) button.
Note regarding contact protection:
The machine is
only secure for operations again once all plastic
parts have been inserted.
Special accessories
The following special accessories are available from
your Service Force Centre or your specialist dealer:
Intermediate installation kits for
stacked washer and dryer
These intermediate installation kits can be used to
arrange the dryer and an AEG-Electrolux washing
machine (60cm wide, front loading) as a space-sav-
ing washer/dryer stack. The automatic washing ma-
chine is at the bottom and the dryer is at the top.
Two versions can be supplied:
Installation kit for external con-
densed water drain
Installation (125 122 510) kit for direct draining of
condensed water into a basin, spigot, drain, etc. The
condensate tank then no longer has to be emptied; it
must however remain in its position in the appliance.
To switch off the TANK WARNING indicator, see the
section “Setup, Condensate tank indicator”
Max. pumping height: 1m from the surface on which
the dryer is standing; max. pumping length: 3m
–
without stacker plate
916.018 902
–
with extractable stacker plate
916.018 903
