24
Cleaning the drum
1
Caution!
Do not use abrasives or steel wool to
clean the drum.
3
Lime in the water or cleaning agents may form
a barely visible lining on the inside of the drum.
The degree to which the laundry has been
dried is then no longer detected reliably. The
laundry is damper than expected when re-
moved from the dryer.
Use a standard domestic cleaner (e.g. vinegar-based
cleaner) to wipe down the inside of the drum and
drum ribs.
Clean operating screen and
housing
1
Caution!
Do not use furniture cleaners or ag-
gressive cleaning agents to clean the ma-
chine.
Use a damp cloth to wipe down the operating screen
and housing.
What to do if…
Remedying small malfunctions
If while the appliance is operating a short acoustic
signal sounds 3 times (if the acoustic signal is set)
and one of the following messages appears in the
display:
–
PLEASE CHECK THE LOAD,
–
PLEASE CLOSE THE DOOR,
please have a look at the following table.
When the fault has been remedied, press the START/
PAUSE/ button.
If “Warning:
E
and number or letter” is displayed:
Switch the appliance off and on again. Reset pro-
gramme. Press the START/PAUSE button.
If the error appears again, please contact the Cus-
tomer Care Department, stating the error code.
Problem
Possible cause
Remedy
Dryer is not working.
Mains plug is not plugged in or fuse
is not working correctly.
Connect the plug to a mains socket.
Check fuse in fuse box (domestic instal-
lation).
Door is open.
Close door.
START/PAUSE button pressed?
Press the START/PAUSE button again.
Drying results unsatisfactory.
Wrong programme selected.
Select a different programme the next
time you dry (see section “Overview of
programmes”).
Fluff filter blocked.
Clean fluff filter.
Heat exchanger blocked with fluff.
Clean heat exchanger.
Incorrect amount of washing.
Observe recommended loads.
Ventilation slots in base area cov-
ered up.
Uncover ventilation slots in base area.
Residue on inside surface of drum or
drum paddles.
Clean inside surface of drum and drum
paddles.
Adjust using the
¤
DRY LEVEL option
(see section “Drying, Setting options”.)
Display shows:
PLEASE CLOSE THE DOOR.
Door not closed properly.
Close door - there should be an audible
click.
Restart the programme.
