Electrolux EACM-09 HR/N6, Руководство пользователя

Страница: 10 / 20

10
Install the exhaust duct into the window
Remove the unit with the packed exhaust duct
next to the window, and then connect the
adaptorB (flat mouth) of the exhaust duct with
the window. (Fig.E)
Fig. E
Install the exhaust duct into the wall
1. Prepare a hole in the wall. Install the wall
exhaust adaptor onto the wall by using 4
expansion screw sleeve and type C screws,
be sure to fix thoroughly.
2. Connect the exhaust duct to wall exhaust
adaptor.(Fig.G).
Expansion screw sleeve
position
Wall exhaust
adaptor
Adaptor B
(round mouth)
Adaptor
cap
maximum: 120cm
minimum: 30cm
Note: Cover the hole
using the adaptor cap
when not in use.
Fig. G
Note:
I. The duct can be compressed to 270mm
minimum and extended to 1500mm maximum.
It is better to keep the duct length to a
minimum length.
2. Stretching or bending the duct excessively
will affect the cooling efficiency.
(As the following fig. Shows)
Do not!
Yes!
Without installation
If the unit does not have the window slider
kit and wall exhaust, and the Adaptor В is
like this ,as shown in Fig H. You can open the
window slightly and position as shown in Fig I.
Fig. H Fig. I
Water drainage
During dehumidifying mode, remove the upper
drain plug from the back of the unit. Attach the
drain hose to the hole. Place the other end of
the hose in the drainage way or other drain
areas.
Drain outlet
*If the unit you bought has the pump drain
outlet, as shown below, please drain in this
way:
Remove the pump drain plug from the back
of the unit, attach the drain hose to the hole.
Place the other end of the hose in the drain-
age way or other drain areas.
Pump
drain outlet
Note: Make sure the hose is secure and there
are no leaks. Direct the hose toward the drain,
making sure that there are no kinks that will
stop the water flowing. Place the end of the
hose into the drain and make sure the end of
the hose is down to let the water flow smooth-
ly. Do never let it up.