dimension & installation guide
built-under dishwasher – DX303
page 4
connecTing The Drain hose
• The drain hose must be free of kinks and obstructions.
• The highest point of the hose should not be more than
1 metre from the floor and should have a continous fall.
• The drain hose may be lengthened using additional lengths
and connectors, which can be purchased from Electrolux
Spare Parts.
The extension length must not exceed
2 metres.
Remove internal membrane from drain spigot.
When connecting the drain hose to an under sink trap spigot,
the entire plastic membrane must be removed.
Failure to remove all the membrane will result in food particles
building up over time eventually blocking the dishwasher drain
hose spigot.
KicKplaTe aDjusTmenT
If your dishwasher is supplied with a kickplate panel, you may
need to adjust the height of the kickplate to cover the gap at
the bottom front of the dishwasher.
To adjust the height:
• Loosen the two screws that secure the kickplate.
• Reposition the panel.
• Secure the kickplate with the two screws.
cusTom-maDe KicK panel
On built-under and full stainless steel door models, for best
cosmetic appearance, we recommended that you manufacture a
custom-made kick panel that matches your kitchen cabinetry.
• A notched continous panel is required to prevent door swing
inteference and to maintain kick panel alignment with adjacent
cabinets.
• Cut a notch in the kick-panel deep enough to allow the door to
swing freely under the dishwasher.
• Check for inteference by slowly opening and closing the door.
If the door touches the kick panel, trim to prevent inteference.
• Secure the kick panel to adjacent cabinets in such a manner that
it may be removed if service is required.
elecTrical connecTion
WARNING
• Safety standards require the appliance to be earthed.
• Prior to using the appliance for the first time, ensure
that the rated voltage and type of supply on the rating
plate match that of the supply where the appliance is
to be installed. The fuse rating is also found on the
rating plate.
• Always plug the mains plug into a correctly installed,
approved socket.
• Multi-way plugs, connectors and extension cables must
not be used. This could constitute a fire hazard through
overheating.
• If necessary, have the domestic power outlet replaced. If
the electrical supply cord has to be replaced, contact your
local Customer Care centre.
• The plug must be accessible after the appliance has been
installed.
• Never unplug the appliance by pulling on the cable. Always
pull the plug.
• Ensure that the dishwasher has been tested using the rinse
& hold or quick 30 cycle and that the dishwasher fills with
water, washes and drains with no leaks.
The manufacturer accepts no liability for failure to observe the
above safety precautions.
Remove entire
internal membrane
© Copyright 2007 Electrolux Home Products Pty Ltd ABN 51 004 762 341
DISH303INSTALL_Jul07
