dimension & installation guide
built-under dishwasher – DX303
page 2
levelling
Good levelling is essential for correct closure and sealing of
the door.
When the appliance is correctly levelled, the door will not
catch or rub on either side of the cabinet.
Leave a space of 2mm between the top of the dishwasher
and the underside of the kitchen counter.
securing The Dishwasher
Secure the dishwasher
by screwing it firmly in position under the bench or to the
cupboard beside it (refer to diagram on previous page). Use
the angular brackets supplied which are fitted into the slots on
top of the dishwasher (more detail is shown in the caution note
below). Tighten the machine in position (upwards or sideways)
by using the screws supplied (3.5 x 16mm). Tighten the screws
so that the dishwasher cannot tip forward and cause damage
when the door is open and the baskets are fully loaded.
CAUTION
The dishwasher must be secured to the underside of
the worktop or to adjacent cupboards by using the
brackets supplied.
Failure to do this can cause injury or damage.
Under no circumstances may holes be drilled
through the sides of the dishwasher since this could
damage the hydraulic components.
CAUTION
Carefully follow the instructions on the template
enclosed with the product for building the
dishwasher under a counter.
No further openings for venting of the dishwasher
are required, but only to let the water fill and drain
hose and power supply cable to pass through.
The height of the recess where the dishwasher is to be installed
can vary between 825mm and 885mm from the floor since the
dishwasher is fitted with adjustable feet (max. 60mm).
Leave a space of 2mm between the top of the dishwasher and
the underside of the kitchen counter.
FiTTing The sTeam proTecTion
Fit the steam protection onto the front part of the worktop,
using the screws provided.
Check if the dishwasher
is levelled
600mm
825-880mm
600mm
