Electrolux 1458528, Руководство пользователя

Страница: 21 / 30

electrolux side by side refrigeration ice and water dispenser 17
tips and information
• Ice cubes stored too long may develop an odd flavour.
Remove the ice container and discard the ice cubes.
When replacing the tray, ensure that the wire signal
arm (see diagram bottom left) sits within the ice cube
container. The ice maker will then start producing ice.
• Occasionally shake the ice container to keep ice separated.
• After you take delivery of the refrigerator, keep the ice
maker switch in the “OFF” position until the refrigerator
is connected to the water supply. The switch should also
be kept in the “OFF” position whenever the water supply
is turned off.
caution
If the dispensing paddle is pushed for more than
4 minutes, the dispenser motor may overload and
stop. The overload protector will reset automatically
after 3 or 4 minutes.
• If a large quantity of ice is needed at one time, it is best
to remove cubes directly from the ice cube container
• When the ice maker is operating, it is normal to hear
the sound of:
– the motor running.
– ice dropping into the ice container.
– the water valve opening or closing.
– ice loosening in the tray.
– running water.
Cleaning the ice dispenser
Clean the dispenser and ice container at regular intervals,
particularly before you take a vacation or move, also clean
the dispenser if it sticks.
To clean the dispenser:
1. Switch the ice maker switch to the “OFF” position.
2. Remove the ice container by lifting it up and
out. Empty and carefully clean the container with
mild detergent. Rinse carefully ensuring no traces
of detergent remain. Do not use harsh or abrasive
cleaners. Allow the ice container to dry completely
before replacing it in the freezer.
3. Remove ice chips from the shelf and chute that support
the ice container; clean these areas.
4. Replace the ice container. Ensure the wire arm sits within
the ice cube container. (see diagram below)
5. Turn the ice maker switch back to the “ON” position.
wire arm
ice cube container
warning
Do not use the ice chute as a handle when removing or
replacing the ice storage bin. Do not put fingers up ice
chute. Surfaces there may be sharp.
caution
When removing or replacing the ice bin do not rotate the
auger in the ice bin. If the auger is accidentally turned, you
must realign the auger by turning it in 90° turns until the ice
bin fits into place with the
drive mechanism
auger
Remove and empty the ice storage bin if:
1. An extended power failure (one hour or longer) causes
ice cubes in the ice storage bin to melt and freeze
together and jam the dispenser mechanism.
2. If the ice dispenser is not used frequently, ice cubes
will freeze together in the bin and jam the dispenser
mechanism. If this happens remove the ice storage bin
and shake it to loosen the cubes.
caution
NEVER use an ice pick or similar sharp instrument to break
up the ice. This could damage the ice storage bin and
dispenser mechanism.