Electrolux 10 GN 1/1, Руководство пользователя

Страница: 32 / 38

32
Anom-
aly
Type of
anomaly
Description
Possible causes Actions
Htd Stops oven Drain temperature
above safety limit Possible lack of water in the
drain system.
• Check that the oven has water supply;
• Pour some water on the bottom cavity filter;
• Wait for the alarm to blink off;
• If the problem persists, call Service.
LPIn Stops
cycle Boiler level sensor
problem
• Humid lime shortcutting
boiler level sensors.
• Insulation issues with the
boiler level sensors
The oven can continue to operate in convection
or in ISG mode.
• There is a problem with the water level in the
boiler: run a cleaning program including the
rinse and descale cycle and use 2 tabs C25
only. (Follow the procedure as per User
Manual);
• If the problem persists, call Service.
MCbM Stops oven Lower inverter commu-
nication problem
• Issue with the motor
inverter;
• Connection or electrical
issue.
Communication error with lower cavity motor
inverter.
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
MCtM Stops the
oven Upper inverter commu-
nication problem
• Issue with the motor
inverter;
• Connection or electrical
issue,
Communication error with upper cavity motor
inverter.
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
PFAC Stops oven Factory parameters
map corrupted Issue with the SW or with
the HW
• Try to switch the oven OFF/ON.
• If the problem persists, call Service.
SbbU Stops
boiler gas Boiler gas fan speed
issue
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
Burner fan does not reach the desired speed.
Call Service.
SbCd Stops
cycle Cavity lower gas
burner blower speed
issue
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
Burner fan does not reach desired speed.
Call Service.
SbCU Stops
cycle/
convection Cavity upper gas
burner blower speed
issue
• Burner blower motor
overload due to dirt or
oxidation;
• Other electrical/mechani-
cal issue.
Burner fan does not reach desired speed.
Ovens with boiler can cook in 100
℃ steam
mode. To restore full oven functionality call
Service.
SLUS Stops
boiler
cycles Water boiler working
level not reached in
time
• Water supply valve
closed or partly closed;
• Temporary lack of water
supply pressure;
• Boiler water level sensor
failure;
• Boiler leakage: drain
valve or fracture.
• Ensure the water supply valve is fully open
and the water filter has no obstructions. Clean
it if needed;
• The oven can continue to work in Convection
mode;
• Unless the water is missing from the mains,
the oven can continue to work in recovery
mode
• Call Service to restore boiler functionality.
If the fault persists after carrying out the above checks, contact the Customer Care Service, remembering to specify:
A. the type of fault;
B. the appliance PNC (production number code);
C. the Ser. No. (appliance serial number).
NOTE!
The appliance PNC and serial number are essential for identifying the type of appliance and date of manufacture: