Electro tracER-A, Быстрый старт

Страница: 4 / 6

Dual Range Tester – R18
A good practice to adopt is to start all measurements with the DRT set to the low current setting,
observe the waveform pattern achieved and then briefly move the switch to the high setting to
determine if a better representation is possible.
On the next page a number of representative waveforms are shown to guide initial testing. Over time
and with use of the DRT you will quickly build up a knowledge of what trace is created for what
component, keeping a note/drawing of this will aid future determinations and troubleshooting.