EVID C12.2 Ceiling Speaker Installation and Operations Manual
6
Ceiling Tile Installation
Step 1: Cut the Hole
Cut out the hole by tracing the cardboard template or with a circular cutter set to the
appropriate cutout size. If the wire has been pre-installed, pull the wiring through the cutout
hole.
Figure 5:
Cut Ceiling Hole
Step 2: Install C-Ring and Tile Rails
For suspended ceiling installations, insert the C-ring through the hole cut in the ceiling tile.
Place the C-ring around the hole with the tabs located as shown in Figure 6. Insert the tile
rails through the cut hole in the ceiling tile. Snap the two rails into the two tabs in the C-ring
and align the rails so that the ends extend OVER the T-channel grid on the side of the tile.
Secure the rails onto the C-ring tabs by inserting a screw though each tab into the rail, as
shown in Figure 6.
Figure 6:
Secure Rails to C-Ring
