Electro-Harmonix Forty-five thousand, Руководство пользователя

Страница: 4 / 24

How to Record a Multi-Track Loop
1. Plug your instrument into either the LEFT or RIGHT INPUT
jacks and adjust the corresponding INPUT knob so that
the Clip LED (Light Emitting Diode) barely lights up on your
loudest notes.
2. Connect the MONITOR OUT jack to an amplifier or mixer,
turn up the HEADPHONE knob to approximately 50%.
3. Plug the AC Adapter into an AC outlet and insert its output
plug into the power jack on the rear panel of the 45000.
4. Raise the DRY OUT Fader so that you can hear your instrument.
5. Raise the TRACK 1 Fader to hear your recording when you
finish.
6. Make sure the QUANTIZE LED is off.
7. If you do not want to hear the CLIX metronome, turn the
CLIX LEVEL knob down to zero, otherwise adjust to taste.
The tempo of the CLIX is adjusted using the TEMPO slider.
8. Set the TEMPO slider to 50% or your preferred tempo is
listening to the CLIX.
9. Press the NEW LOOP button to put the 45000 into record-
ready mode. You should see the RECORD LED blink.
10. Press the RECORD button to immediately start recording.
Play your instrument. The 45000 will record onto TRACK 1.
11. When you are finished playing, press either the RECORD
or PLAY button to stop recording. Pressing RECORD will
stop recording and stop the 45000. Pressing PLAY will
loop the 45000 back to the beginning, put the 45000 into
OVERDUB mode and automatically continue recording
onto TRACK 2. To exit OVERDUB mode, press the RECORD
button. You could also press NEW LOOP to end recording
and begin playback immediately.
12. If you want to record on another track, press the TRACK
SELECT button to cycle through the 4 tracks. The track LED
that is lit indicates the track that is enabled for recording.
How to Overdub onto a Track
1. You can continuously overdub onto any one of the tracks.
2. Record a New Loop onto TRACK 1, as done above in the
How to Record a Multi-Track Loop section.
3. Hit the TRACK SELECT button until TRACK 1 is lit.
4. Move the TRACK 1 Fader to 100%. When in Overdub mode,
the track’s volume slider acts like a Feedback control on
a delay pedal. For example, if the TRACK 1 slider is set to
50%, each time the loop cycles, the volume of the previ-
ously recorded audio on TRACK 1 will be halved.
5. Press the RECORD button, both the RECORD and PLAY LEDs
will light up. This means you are in Overdub mode. Since
TRACK 1’s LED is lit, you are overdubbing onto TRACK 1.
How to Record 2 Tracks
Simultaneously (aka Stereo):
1. Press the STEREO MODE button. Its LED will light and you
will notice that a pair of TRACK LEDS lights, either 1 & 2 or
3 & 4.
2. After inserting your instrument(s) into the LEFT and RIGHT
INPUT jacks, adjust the INPUT Level knobs so that the CLIP
LEDs barely light.
3. Press the NEW LOOP button to put the 45000 into record
ready mode. The RECORD LED will blink steadily.
4. Press the RECORD button to begin recording immediately.
5. To stop recording, hit either the RECORD or PLAY buttons.
NEW
LOOP
CLIP
L INPUT R
DRY
OUT
S
D
C
A
R
D
Quick Start Guide
3