Page
8
of
18
FIG D
VENTING THE AIR CONDITIONER
Your window kit has been designed to fit most standard horizontal sash and vertical sliding
windows. However, it may be necessary to extend or reduce the size of the sliding adapter to
match certain types of window. Please refer to fig. A and fig. B for minimum and maximum window
openings.
Horizontal Window
Vertical Window
Fig. B
Window slide kit
min: 67.5cm
max.: 125cm
min: 67.5cm
Fig. A
max.: 125cm
Nut
Fig. C
Bolt
Fix the nut and bolt (fig C) or the plastic bolt (fig D) to stop the slider from moving (certain models only).
Note: The window kit is not designed or to be used with other style of windows than sash or sliding windows as shown
above. However the kit may be adapted for other windows or the fish tail adaptor can be used with most windows /
doors. When using the cooling mode ensure that the opening left is as small as possible you can use curtains or other
materials to block the openings. The best form of installation is through a wall duct. We recommend that you use a
self-opening draft shutter if you use the wall ducting.
Please note that the unit will need to be vented out in heating mode, ideally through the wall. By properly venting you
expel cold air from your room while efficiently heating it.
When used in dehumidifier mode the unit does not need venting, but please note a lot of water will be produced.
Important safeguards
The length of the soft hose extends from 30 cm to 160 cm. If hose is extended
beyond this length the unit may malfunction and this can invalidate the
warranty. The outlet vent must be well ventilated and not obstructed as
this will cause the unit to overheat. Avoid bending the air hose more than
30 degrees.
Before operating the unit please ensure both back filter and side filters
are clean and not touching the compressor coil.
To open the top filter use the catch to pull the filter out.
Bottom filter is fixed with a screw, use a cross screwdriver to remove it.
Please read full maintenance instructions including end of the season
storage.
