Page
11
of
18
1. ON/OFF
：
Press this key to turn the unit on/off. The remote LCD screen will be on up when the unit is on
2. SET
(UP): Press this key to turn up the temperature or adjust timer.
3. SET
(DOWN)
：
Press this key to turn down the temperature or adjust timer.
On temperature setting mode it will increment or decrement with 1 Celsius degree at a time between
16-32⁰C
On timer setting mode it will increment or decrement with 0.5 hours at a time between 0.5-10 hrs and 1
hour increment between 10-24 hrs
4. Mode
：
Press this key to choose cooling, dehumidifying, heating, fan mode or Auto. Will cycle
AUTO>COOL>DRY>HEAT>AUTO
Cooling Mode: thermostat and fan speed can be set and the unit will turn the compressor on and off
according to the set temperature. Also timer off can be set in running mode or standby mode to restart the
unit. Unit will need venting as per venting section of the user manual.
Dehumidifying Mode: the remote will enable temperature or fan speed adjustment but not thermostatic
control will be achieved. The unit will turn the compressor on when needed to achieve maximum
dehumidification. Also timer off can be set in running mode or standby mode to restart the unit. Unit will not
need venting but we recommend having it permanently drained via a drainage tube or drained in a large
external bucket with the timer enabled.
Heating Mode: thermostat and fan speed can be set and the unit will turn the compressor on and off
according. Also timer off can be set in running mode or standby mode to restart the unit. Unit will need
venting as per venting section of the user manual.
Auto Mode: Thermostat is set to 24⁰C unit cooling or heating accordingly. No other settings are active.
Note: On power cut the unit will restart on the last user mode.
5. Clean: in standby mode sets the self-cleaning function for when the unit is started
a. When the unit is on standby mode press “CLEAN” on the remote control, the remote will show “CL”. When the
unit starts using the remote control the unit will run for maximum 35 minutes on self-cleaning mode. This
function will clean the dust on the evaporator and dry the inside of it to prevent mould and bacterial growth.
The normal operation will be resumed once cleaning cycle will be finished. Do not stop the unit before using it
for 35 minutes if the cleaning mode is activated.
NOTE: Self-cleaning function is to be used with normal filter maintenance alternatively the dust or fluff may
block the evaporator tray and self-cleaning will stop being efficient.
6. Speed
：
Press this key to set low/medium/high fan speed. Fan speed adjustment will not work in the Auto
Mode
7. Sleep: Press this key to enable sleep mode.
SLEEP button
When pressing the SLEEP button, the sleep LED indicator light of indoor unit flashes on.
In cooling mode after the setting of sleeping mode, the thermostat set temperature will increase 1⁰C after 1 hour
and with another 1⁰C after another hour
In heating mode after the setting of sleeping mode, the thermostat set temperature will decrease 2⁰C after 1
hour and with another 2⁰C after another hour
The air-conditioner runs in sleeping mode for 7 hours and then stops automatically.
Note: press the MODE or ON/OFF button on the remote will clear the SLEEP mode.
8. Turbo: One key setting to achieve maximum output both in cooling or heating mode. Fan and compressor will
run at maximum speed.
9. Swing
：
Press this key to control swing function.
Pressing the SWING key can switch between auto-swing mode and locking the louvres movement into the
desired position. Pressing again the SWING key will resume auto-swing mode.
10. Follow: Change the temperature sensor reading to remote
Press this to change the temperature sensor reading from the air conditioner to the remote temperature sensor.
The LED display on the units will show the user set temperature while the remote will show the room
