Page
15
of
18
Maintenance
Cleaning
Please shut off the unit and unplug from the mains before cleaning or performing any
maintenance
Clean the surface
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage.
Air filter cleaning
a)
Clean the air filters every 2 weeks. If the air filter is blocked with dust, the unit’s performance will be
significantly affected.
b)
Pull out the top and bottom filters as pictured below. The bottom filter is fixed with a screw.
c)
Wash the air filters by immersing them in warm (about 40
℃
) water with a neutral detergent.
d)
Rinse it and then dry it thoroughly.
e)
Carefully re-install air filters
Open from here
Please note: If the optional active carbon filter is in use it should be changed every 2-3 weeks
based on the environment. The unit can be installed with HEPA filters but this may reduce its
efficiency.
End of Season Maintenance
：
1.
Use the unit on heat mode for 30 minute
2.
Pull out the plug from the bottom drainage hole and empty the
internal tank. You can also drain the water by leaning the unit.
3.
Then switch the unit to Fan mode, and select low fan speed.
4.
Keep the unit in this mode for 6-12 hours - until the conduit is dried.
Doing this helps to keep the inside of the unit dry and prevents mold
developing
5.
Turn off the unit and pull out the plug.
6.
Coil the wire and bind it together, then put it into the accessories space.
7.
Separate the air-exhausted pipe and store it safely.
8.
Cover the unit and keep it in a dry place.
9.
Take the batteries out of remote control and store, or dispose, them safely
