14
BURNERS
•
Remove the burner lids and flame spreaders by pulling them upwards and away from
the top plate.
•
Soak them in hot water with a small amount of detergent or washing up liquid.
•
After cleaning, wipe all parts dry and make sure that the flame holes are clean and
completely dry.
•
Wipe the fixed parts of the burner cup with a damp cloth and dry immediately.
•
Gently wipe the ignition device and flame supervision device with a well rung out cloth,
drying immediately after.
•
Make sure that the injector is not blocked and remove any debris around it before
placing the burners back on the top plate.
RE-ASSEMBLE THE AUXILLARY, SEMI-RAPID, RAPID AND TRIPLE CROWN
BURNERS
•
Place the flame spreader (2) on the burner
cup (3) so that the ignition device and the
flame supervision device extend through
their respective holes in the flame spreader.
•
Position the burner lid (1) onto the flame
spreader (2) so that the retaining pins fit into
their respective recesses.
NOTE:
Do not mix the top and bottom. The locating pins must fit exactly into the notches.