14
WATER DRAINAGE
When the water tank is full, the unit will stop operating. When this happens, the TANK FULL light will show on the control
panel, and the unit will bleep.
Note:
Only empty the water tank when it is full or before moving or storing the unit. There are two ways to dispense
collected water.
USE THE INTERNAL WATER TANK
When the tank is full, the unit will stop running, and the TANK FULL indicator light will
display. Grip the tank securely and carefully pull out. Empty the water tank and reinsert it
into the dehumidifier. The tank must be in place and securely seated for the dehumidifier to
operate again. The dehumidifier will re-start when the tank is restored to its correct position.
NOTES:
•
Do not remove the water tank immediately after the unit stops. Please wait a while to avoid
the water dripping into the unit and causing damage.
•
Only empty the water tank when it is full or before moving or storing the unit.
•
Do not rest the tank on the floor because the bottom of the tank could be uneven and the tank may fall, causing water
to spill.
•
When you remove the tank, do not touch sensors or any parts which are situated behind the tank. Doing so may
damage the product. Be sure to push the tank gently all the way into the unit. Banging the tank against anything or
failing to push it securely into place may prevent the unit from operating.
•
Do not remove or damage the float switch in the water tank, otherwise the machine will stop working.
•
Please make sure the water tank cover is put back into place correctly before the water tank is reinserted.
•
If the water tank is inserted incorrectly, the full tank indicator will illuminate. Remove the water tank and reinsert to turn
the indicator off and resume normal use.
•
At all times, avoid water entering the unit. It may cause an electrical hazard and damage the unit.
SET UP CONTINUOUS DRAINAGE
The dehumidifier has a continuous drain hole that can be connected to a plastic pipe with a 15 mm inner diameter (Not Supplied).
Water can be plumbed in or drained into a sink, a larger receptacle or through the wall into an outside drain. Please follow the steps
below to set your unit up for continuous drainage.
1.
Cut off the cover for the continuous drain on the back of the unit.
2.
Pull out the water tank and connect a water tube with an inner diameter of 15mm to the drain connector, and ensure
the connection is tight
3.
Replace the water tank into position within the unit.
This unit uses gravity to dispose of the water collected and as such the drain should be lower than the dehumidifier water outlet. Be
sure to run the water pipe downward and let the water flow out smoothly. Do not kink or bend the pipe.
NOTE
: When the continuous drain feature is not being used, remove the pipe installation, to start the water collecting in the water tank.
The permanent drain can be used in conjunction with a water pump (e.g. when draining from a cellar) to lift the water upwards.
Содержание DESD9LW
Страница 7: ...7 PARTS Top Display...
