electrifly SR22 Turbo, Инструкция по эксплуатации

Страница: 10 / 24

10
HOW TO CUT COVERING FROM BALSA
Use a soldering iron to cut the covering from the stab. The
tip of the soldering iron doesn’t have to be sharp, but a fi ne
tip does work best. Allow the iron to heat fully.
Use a straightedge to guide the soldering iron at a rate
that will just melt the covering and not burn into the wood.
The hotter the soldering iron, the faster it must travel to
melt a fi ne cut. Peel off the covering.
❏
5. Before gluing the stab into position in the fuselage,
check the fi t of the elevator joiner wire by inserting it into the
holes in the leading edge of the elevators. Lay the elevators
on a fl at work surface and confi rm that they both lay fl at. If
not, remove the wire from the elevators and use pliers to
bend or “tweak” it until they do. Do not attempt to bend the
joiner wire while it is installed in the elevators!
❏
6. Insert the elevator joiner wire into the aft end of the
stab slot. Insert the stab into the slot and center it left and
right. Measure from the wing tips to the stab tips and make
those distances equal. Confi rm that the stab and wing are
still parallel. A weight can be added to one side of the stab
to make any small corrections. When satisfi ed, wick thin CA
along the edges where the stab meets the fuselage. When
the CA has dried, confi rm that the stab is thoroughly glued
to the fuselage. Note: epoxy can also be used in this step.
DRILL A 5/64" [2mm] HOLE,
3/8" [9.5mm] DEEP, IN CENTER
OF HINGE SLOT
CUT THE COVERING
AWAY FROM THE SLOT
❏
7. Drill a 5/64" [2mm] hole 3/8" [9.5mm] deep into the
center of each hinge slot in the elevator halves and stab.
Trim the covering away from each hinge slot to ensure that
the hinges will be properly glued in place.